Wall-Mounted Secure Pin Hook (Cross Type, Ceiling Single)

Country of Origin: China
Material: Mounting Parts: ABS Resin, Hook: Stainless Steel, Cap: Polyethylene, Pin: Stainless Steel
Product Size: cm × cm × cm
Contents: 2 pieces
Type: No assortment
Mountable Locations: Cross-covered gypsum board wall 9mm or thicker, thin board wall 5mm or thicker, printed plywood
Non-mountable Locations: Sound-absorbing board (gypsum sound-absorbing board, rock wool sound-absorbing board, etc.), hard walls such as concrete, brick, and tile, fragile walls such as earthen walls and plaster
Direction: × Horizontal direction, × Diagonal direction, 〇 Vertical downward direction
Load Capacity: 500g
*The load capacity is only a guideline. It may vary slightly depending on the mounting location, so please be cautious.
*The tip of the pin is sharp. Please be careful to avoid injury.

◆ Installation Method
1. Insert the mounting part into the hook hole and press it against the wall.
2. For gypsum board, use a coin, and for new building materials like board walls, use a hammer to push each pin diagonally towards the center.
3. After confirming that all three pins are fully pushed in, attach the cap.

◆ Removal Method
Remove the cap, lift the heads of the three pins with a flathead screwdriver, and completely pull them out from the mounting part using pliers.
*Attempting to remove the hook may damage the wall.

● The tip of the pin is sharp. Please handle with care.
● The strength of the hook may vary slightly depending on the material of the mounting location.
● Do not pull on items hung on the hook.
● To prepare for any potential falls or detachments, ensure that there are no people or fragile items around the mounting area.
● Use in locations where marks left behind will not be an issue.
● Do not hang valuables or fragile items.
● Do not hang items exceeding the load capacity.
● Use and store out of reach of children.
● Avoid direct sunlight and high temperature and humidity for use and storage.
● If deformed or damaged, stop using immediately.
● Do not place near fire or heat sources.
● Do not use for purposes other than intended.

Features:
Mounting locations for ceiling installation: Cross-covered gypsum board walls 9mm or thicker, thin board walls 5mm or thicker, printed plywood. Locations where installation is not possible: Sound-absorbing boards (gypsum sound-absorbing boards, rock wool sound-absorbing boards, etc.), hard walls such as concrete, brick, and tile, fragile walls such as earthen walls and plaster. Directions: × horizontal direction, × diagonal direction, 〇 vertical downward direction. Load capacity: The strength of the hook may vary slightly depending on the material.

Warnings / Instructions:
* The weight capacity is only a guideline. It may vary slightly depending on the installation location, so please be cautious.
* The tips of the pins are sharp. Please be careful to avoid injury.

◆ Installation Method
1. Insert the mounting part into the hook hole and press it against the wall.
2. For gypsum board, use a coin, and for new building materials like board walls, use a hammer to push each pin in at an angle towards the center.
3. Confirm that all three pins are fully pushed in before attaching the cap.

◆ Removal Method
Remove the cap, lift the heads of the three pins with a flathead screwdriver, and completely pull them out from the mounting part using pliers.
* Attempting to remove the entire hook may damage the wall.

● The tips of the pins are sharp. Please handle with care.
● Installation location
● Do not pull on items hung on the hook.
● To prevent any potential falls or drops, ensure that there are no people or fragile items in the vicinity of the installation area.
● Use in a location where marks left behind will not be an issue.
● Do not hang valuables or fragile items.
● Do not hang items exceeding the weight capacity.
● Use and store out of reach of children.
● Avoid direct sunlight and high temperature and humidity when using and storing.
● If deformed or damaged, stop using immediately.
● Do not place near fire or heat sources.
● Do not use for purposes other than intended.

Country of origin: China.

This product is shipped from Japan.